This is my 9C adapter for the AeroFly Plus interface version

I normally fly with a 9C however I have an 8U for my simulator

I only built this to see if I could figure it out

It turns itself on/off by using the plug - no switch

It does not emit any RF signal that I can detect

I used a 15 watt soldering iron and small alligator clips for heat sinks

My cost was $4.49+shipping from Tower Hobbies and $0.50 for heat shrink tubing

I also cut a buddy box trainer cable in half and made one for a flying buddy

( Just different colored wires in the trainer cord )

~ Bowser ~

My schematic below

BACK TO HOME PAGE